Franke Consumer Products Ventilation Hood FGA 364 W Bedienungsanleitung PDF herunterladen (Seite 8)

INSTALLATION

Wall drilling and bracket fixing

12a

18"5/16

4"9/164"9/16

7.2.1

24"

÷1/16"

Wall marking:

• Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the

center of the area in which the hood will be installed.

• Draw a horizontal line at 24” above the hob.

• Place bracket 7.2.1 on the wall as shown about 1/16” from the ceiling or upper limit aligning

the center (notch) with the vertical reference line.

• Mark the wall at the centers of the holes in the bracket.

• Place bracket 7.2.1 on the wall as shown at X” below the first bracket (X = height of the up-

per chimney section supplied), aligning the center (notch) with the vertical line.

• Mark the wall at the centers of the holes in the bracket.

• Mark a reference point as indicated at 4” 9/16 from the vertical reference line and 18” 5/16

above the horizontal reference line.

• Repeat this operation on the other side.

• Drill ø 5/16” holes at all the center points marked.

• Insert the wall plugs 11 in the holes.

• Fix the lower bracket 7.2.1 using the 12a screws supplied.

• Fix the upper bracket 7.2.1 and the air outlet connection support 7.3 together using the 2

screws 12a supplied.

• Insert the two screws 12a supplied in the hood body fixing holes, leaving a gap of 3/16 ”

between the wall and the head of the screw.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Keine Kommentare

Franke Consumer Products Ventilation Hood FGA 364 W Bedienungsanleitung Seite 8